0710-2869525
Hotline
-
企业展示
-
企业展示
PRODUCTS
NEWS
CONTACT
Mobile website
Xiangyang five two five Chemical Machinery Co., Ltd. all rights reserved 鄂ICP备16020412号-1
Powered by www.300.cn
ABOUT US
Product center
Horizontal Chemical Axial Flow Pump
Design pressure: iOMpa
Flow: 250-17000m3, h
Head: 2 ~ 8m
Turn i child 300 ~ 800r / min
caliber. 350 ~ 1500mm
Medium temperature: l50 ℃
PROFESSIONAL DEDICATION
TRANSFER VALUE
Horizontal Chemical Axial Flow Pump
parameter:
Introduction
ZB series horizontal chemical axial flow pump is a single-stage cantilever structure, which is designed for the corrosive abrasive media containing solid particles in the high-flow and low-head evaporative cycle of phosphorus and compound fertilizer project. Is the end of the advantages of domestic and foreign products, the application of SolidWorks three-dimensional dynamic simulation, independent research and development of high anti-cavitation performance products, flow from 17000m3 / h. The series of pumps a wide range of performance, reasonable structure, good anti-cavitation, high reliability, easy installation and maintenance. In the domestic variety of ammonium phosphate, phosphoric acid device has been widely used. The main application of a large number of axial flow pump pump pump.
Model Description
Structural features
1-Shroud 2-Inlet Dock 3-Impeller 4-Pump 5-Shaft 6-Bushing 7-Shaft Sleeve 8-Seal Ring 9-Seal Ring Packing Gland-10 Filler 12-Shaft Seat 13-bearing 14-air hole cover 15-bearing sleeve 16-rear bearing gland 17-rear hanger plate -18 oil spill parts -19 front axle without gland -20 front block acid plate -21 drain pipe 22- Joint 23-axis pad with cantilevered structure, simple structure, easy maintenance, no need to remove the pump and pipeline, the wheel can be installed to change the medium flow.
Impeller and short section with the transport of abrasive materials, just replace the short section can be, to improve the life of the machine.
The impeller nut is also provided with an impeller nut cap, which protects the impeller nut from contact with the media and is tightened with a double nut (positive locking nut, reverse locking nut). Pump speed is low, running smoothly, so the impeller life is long.
Seal with mechanical seal or packing.
Filler seal is a new type of double packing device, not only in the filler material on the optimal combination to ensure the reliability of the seal, but also in the filler before a wear ring, the effective protection of the filler, the better extension The filler life, reduce the number of maintenance and maintenance, and easy disassembly, sealing effect.
Mechanical seal with double-ended mechanical seal centralized waterless seal.
Bearings are imported bearings, noise, machine life is long.
Over flow parts material
Over-current parts material can be used 2205 316,316L.904L. 20 # Taiwan and other materials. Shaft with 2205.316L.14462 material.
transfer method:
Direct connection: The pump is connected to the motor via an elastic pin coupling.
Belt drive: through the V-belt drive, change the speed to adjust the pump performance.
Reducer: through the reducer using parallel or right angle axis and other means of transmission.